Wireless Modem Router
73
Group Name: The name of a configured rule.
WAN Interface used in the grouping: WAN connection to which the interface grouping rules apply.
Available LAN Interfaces: LAN interfaces that can be used for interface grouping.
Grouped LAN Interfaces: LAN interfaces that use specified WAN interface.
To create a new interface group:
Enter the Group name and the group name must be unique and select either 2. (dynamic) or 3. (static) below:
If you like to automatically add LAN clients to a WAN Interface in the new group add the DHCP vendor ID string. By
configuring a DHCP vendor ID string any DHCP client request with the specified vendor ID (DHCP option 60) will be
denied an IP address from the local DHCP server.
Select interfaces from the available interface list and add it to the grouped interface list using the arrow buttons to create
the required mapping of the ports. Note that these clients may obtain public IP addresses.
Click Apply/Save button to make the changes effective immediately.
_________________________________________________________________________________________________
Note:
If a vendor ID is configured for a specific client device, please REBOOT the client device attached to the modem to
allow it to obtain an appropriate IP address.
_________________________________________________________________________________________________
4.2.15 IP Tunnel
This section explains the following information:
• IPv6inIPv4
• IPv4inIPv6
IPv6inIPv4
Click IPv6inIPv4 and Add to enter the following screen:
To Next Page
Loading...
Need help?
General
