BQ79600EVM Quick Start Guide
www.ti.com
10
SLUUC57A–October 2019–Revised June 2020
Submit Documentation Feedback
Copyright © 2019–2020, Texas Instruments Incorporated
BQ79600-Q1 Evaluation Module
4 BQ79600EVM Quick Start Guide
This section includes hardware setup instructions, connection procedures, and software and GUI
instructions.
Figure 6. Basic EVM Setup
4.1 Required Devices for Using the Example Code
The system example code is implemented using the LAUNCHXL2-TMS57012 LaunchPad™ board
(TMS570LS1224 MCU), the BQ79600EVM, and the BQ79616EVM via Code Composer Studio.
The part numbers of the evaluation modules are LAUNCHXL2-TMS57012, BQ79600EVM-030 and
BQ79616EVM-021. These boards are available from the TI eStore (https://estore.ti.com/) or from your
local TI sales representative. For more details and information related to the LaunchPad™modules, see
the specific module user's guide.
4.2 Power Connections
The BQ79600EVM can be powered up either using a 5-V supply or a 12-V supply.
To use the 5-V option, ensure jumpers J1 and J3 are connected in the "5V" position as labeled in the
board, and then connect the positive terminal of the 5-V supply to the "5V" testpoint provided on the
board, and the power supply negative terminal to the "GND" testpoint provided on the board, or any
"GND" standoff provided.
To use the 12-V option, ensure jumpers J1 and J3 are connected in the "12V" position as labeled in the
board, and then connect the positive terminal of the 12-V supply to the "12V" testpoint provided on the
board, and the power supply negative terminal to the "GND" testpoint provided on the board, or any
"GND" standoff provided.
To Next Page
Loading...
Need help?
General
