ThyssenKrupp Flow2 User Manual

Recognizing and resolving signals
Flow2 stairlift
26
3.3 Warning signals while operating the stairlift
Signal on control Meaning Action
Flashing green lamp The batteries of this
control are (almost)
empty and must be
replaced.
Replace the batteries (see §4.2)
of the control concerned.
Flashing red lamp
+ audio signal from
motor.
1. The stairlift
is not parked
on a charging
contact.
1. Drive the stairlift to a charging
contact. If this is not possible,
you can turn the audio signal
off by switching the stairlift
off with the main switch (see
§2.1.3). Then contact your
supplier.
Or:
2.The stairlift has
encountered an
obstacle and will
not move any
further.
2. Move the stairlift in the
opposite direction and remove
the obstacle.
Constant red lamp. There is a
malfunction in the
stairlift.
Switch the stairlift off and then
on again (see §2.1.3). Try to
operate the stairlift. If the stairlift
does not work contact your
supplier. If this situation occurs
while moving, you can always
descend with the emergency
descent system (see §2.1.3).

ThyssenKrupp Flow2 Specifications

General

Brand	ThyssenKrupp
Model	Flow2
Category	Stairlifts
Language	English