Creation:03.09 — 2009 1-3-2
Specifications & Capabilities
D. Engines:
All engines used are fully-electronic diesel engines with electronic engine governors provide
precise frequency regulation and fast transient response. Engine protection such as low oil
pressure, high coolant temperature, and over speed protection are programmed into the
engine electronic control module. An engine diagnostic connector is provided for
communicating with the engine. Engine operating parameters are displayed with electronic
gages via SAE J1939 Controller Area Network, which include:
- Engine Hours
- Engine RPM
- System Voltage
- Oil Pressure
- Coolant Temperature
- % Engine Load at the current RPM
- Active and stored Service Codes
- View Engine Configuration Parameters
A separate analog fuel gage is provided automatic engine cool down and emergency
shutdown are standard engine controls.
2. CUMMINS ENGINE SPECIFICATION:
Manufacturer..................................................................Cummins
Model .............................................................................QSB4.5
Type ...............................................................................Turbocharged, in-line,
4 Cylinder 4-cycle diesel
Gross Rated Horsepower @ governed speed...............130HP/97KW
Governed speed.............................................................2000 RPM
Firing order.....................................................................1-3-4-2
Electrical system............................................................24 Volt, negative ground
Refer to chapter 5 (manufacturer’s literature) for details of Cummins QSB4.5
engine.
To Next Page
Loading...
Need help?
General
