H Starting
0 Preparations
(1) Loosen the air vent screw (2) Connect
the
A connector
on the Iuel tulk cap.
to the engine.
(3)
Fig. 33
Feed fuel to the carburetor by
the primer bulb until firm.
Engine Side
Fig. 35
Fig. 36
Be sure to connect the emergency stop line to your wrist. The engine
is shut down if the stop line switch is disconnected. This is a
safety
measure. designed to protect the driver from propeller injury if he is
thrown overboard.
The engine will not start unless this switch has been
properly
connected and locked beforehand.
NOTES:
Be sure that fhe shift is at neutral when starting the engine.
This model is provided with start in-gearprotection.
33
To Next Page
Loading...
