PRE-OPERATING PREPARATIONS28
6
1. Fully open the air vent screw on the
fuel tank cap and release internal
pressure.
1. Air vent screw
2. Fuel tank cap
2. Open the fuel tank cap slowly.
3. Fill the fuel carefully not to over flow.
4. After filling the tank, close the fuel
tank cap.
ENOM00037-A
ENOW00022-1
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before starting engine.
ENOW00092-A
z Do not overfill engine oil, or engine oil
could leak and/or engine could be dam-
aged. If engine oil level is over upper limit
marks of oil gauge, drain oil to level lower
than upper limit.
z Be sure that outboard motor is in upright
and level position when checking or
changing oil.
z Stop engine immediately if low oil pres-
sure warning lamp is lit or oil leak is found,
or engine could be severely damaged.
Consult dealer.
z Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
ENOM01812-B
1. Place the outboard motor in a verti-
cal position.
2. Turn the top cowl hook levers to
unlock, lift and remove the top cowl.
1. Cowl hook lever
3. Engine oil filling
CAUTION
1
2
ENOF00029-0
SAFE FILL
LEVEL
25 L
NIVEAU
MAXIMUM
ENOF00030-A
CAUTION
To Next Page
Loading...
Need help?
General
