ENGINE OPERATION 43
7
ENON00942-0
Note
z It takes maximum 4 seconds of the
continuous crank before the engine
starts.
z If fail to start the engine, crank again
after 10 seconds or more.
1. ON
2. START
3. OFF
ENON00939-0
Note
The neutral throttle button can not be
push-in when the control lever shift is in
Forward or Reverse.
6. Check the cooling water from cooling
water check port.
ENOM00043-A
ENOW00932-0
Be sure to check that cooling water is com-
ing out of the cooling water check port dur-
ing warm up.
Warm the engine at low engine speeds
for about
3 minutes : above 5°C (41°F)
5 minutes at 2000 min
-1
(rpm) : blow 5°C
(41°F)
This allows the lubricating oil to circulate
to all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
ENOM00044-0
Engine speeds
Idling speed after warming up.
Remark: In case of cold engine starting,
idling speed is increased about 400 min
-1
(rpm) for several minutes.
3. Warming up the engine
CAUTION
Clutch in (In gear) Clutch off (Out of gear)
700 min
-1
(rpm) 700 min
-1
(rpm)