TOHATSU MFS 25C User Manual

ENGINE OPERATION52
7
ENOM00050-0
ENOW00043-A
z Adjust the trim angle when the engine is
stopped.
z Do not put hand or finger in between out-
board motor body and clamp bracket
when adjusting trim angle to prevent
injury in case the outboard motor body
falls.
z Unsuitable trim position can cause loss of
control of boat. When testing a trim posi-
tion, run boat slow initially to see if it can
be controlled safely.
ENOW00044-0
Excessive trim up or down may lead to unsta-
ble boat operation, potentially causing the
steering difficulty that leads to accident
during cruising.
z Do not cruise at high speed if improper
trim position is suspected. Stop the boat
and readjust trim angle before continuing
cruise.
z For outboard motor model with PT switch
on the bottom cowl, do not operate the
switch during cruising, or control of boat
may be lost.
The trim angle of the outboard motor can
be adjusted to suit the transom angle of
the hull, and load conditions. Choose an
appropriate trim angle that will allow the
anti-ventilation plate to run parallel to
the water surface during operation.
ENOM00052-0
Proper trim angle
The position of the thrust rod is correct if
the hull is horizontal during operation.
1. Perpendicular to the water surface
ENOM00053-0
Improper trim angle (bow rises too
high)
Set the thrust rod lower if the bow of the
boat rises above horizontal.
ENOM00054-0
Improper trim angle (bow dips into the
water)
Set the thrust rod higher if the bow of
the boat is below horizontal.
7. Trim angle
WARNING
WARNING
1
ENOF00051-1
ENOF00052-0
ENOF00053-0

TOHATSU MFS 25C Specifications

General

Brand	TOHATSU
Model	MFS 25C
Category	Outboard Motor
Language	English