PRE-OPERATING PREPARATIONS32
6
1. Fully open the air vent screw on the
fuel tank cap and release internal
pressure.
1. Air vent screw
2. Fuel tank cap
2. Open the fuel tank cap slowly.
3. Fill the fuel carefully not to over flow.
4. After filling the tank, close the fuel
tank cap.
ENOM00037-D
ENOW00022-2
The engine oil is drained for shipping at the
factory. Be sure to fill the engine oil to the
proper level before starting the engine.
ENOW00092-1
z Do not overfill engine oil, or engine oil
could leak and/or engine could be dam-
aged. If engine oil level is over upper limit
marks of dip stick, drain oil to level lower
than upper limit.
z Be sure that outboard motor is upright
when checking or changing oil.
z Stop the engine immediately if low oil
pressure warning lamp or oil leak is found,
or engine could be severely damaged.
Consult your dealer.
z Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
1. Place the engine in a vertical position.
2. Remove the top cowl and the oil filler
cap.
3. Fill the engine through filler port with
recommended oil to between upper
limit and lower limit shown on the
dipstick.
4. Tighten the oil filler cap.
SAFE FILL
LEVEL
25 L
NIVEAU
MAXIMUM
ENOF00030-A
3. Engine oil filling
CAUTION
CAUTION
To Next Page
Loading...
Need help?
General
