Fuel (continued)
Biodiesel (continued)
Blended fuel must meet:
ASTM D975 USA
EN 590 European Union
JIS K2204 Japan
Adding Fuel
G423841
1. Park the machine on a level surface, lower the
cutting units, shut off the engine, and remove
the key.
2. Clean the area around the fuel-tank cap
and remove the cap.
3. Fill the tank until the level is to the bottom of
the filler neck
with the specified fuel.
4. Install the fuel-tank cap tightly.
Note: If possible, fill the fuel tank after each
use. Filling the fuel tank minimizes
condensation inside the tank.
Checking the Interlock Switches
CAUTION
If safety interlock switches are disconnected or damaged, the machine could operate
unexpectedly, resulting in minor or moderate injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches daily and replace any damaged
switches before operating the machine.
IMPORTANT
If your machine fails any of the interlock switch checks, contact your authorized Toro
distributor.
3466-702A Page 5–3 Operation: Before Operation
To Next Page
Loading...
Need help?
General
