Name: Toro Hydroject 3000
Brand: Toro
Rating: 5 (1 reviews)

TORO Hydroject® 3000/4000 Components

NOTES

____________________________________________________________________________________________________________

45

Injection Nozzles

The Hydroject® is equipped with 11 injection nozzles. These nozzles convert the high pressure, high volume

water into a high-pressure water jet that aerates the turf.

The injection nozzle consists of the nozzle body, check ball, spring, nozzle tip and nut.

The function of the ball and spring is the keep the high pressure manifold full of water between injection cycles.

The check ball is unseated when the injection pressure reaches 110 PSI.

NOTE: Whenever a nozzle is removed or replaced, a new sealing washer should be used where the

nozzle mounts to the manifold.

NOTE: With the new style nozzle, the nut is torqued to 70-80 ft.lbs.

Blocked Nozzle

Depending on the desired nozzle spacing and configuration, some nozzles may need to be blocked. This is

done by disassembling the nozzle and reversing the ball and spring. By locating the ball at the bottom of the

nozzle, this prevents water flow through the nozzle.

Toro Hydroject 3000 Troubleshooting Guide

Other manuals for Toro Hydroject 3000