Name: Toro Hydroject 3000
Brand: Toro
Rating: 5 (1 reviews)

TORO Hydroject® 3000/4000 Components

NOTES

____________________________________________________________________________________________________________

7

Engine

The Hydroject® is powered by an Onan, 24 HP, air cooled, twin cylinder, electric start, gas engine. The engine

is equipped with solid state ignition, and powers the water pump, water valve, and on the 3000, the hydrostatic

transmission.

The engine uses 3 quarts of 30-weight engine oil and the oil should be changed every 100 hours, after the initial

25-hour change.

Oil Filter PN. 57-8530

The air filter should be serviced every 100 hrs, and the filter element replaced every 200 hrs.

Air Filter foam pre-cleaner PN 82-0670.

Air Filter element PN. 82-0670.

During aeration, operate the Hydroject® at full engine RPM.

Proper engine idle speeds.

Low idle 1500 - 1800 RPM.

High Idle 3500 ± 50 RPM.

Fuel

The fuel tank holds 10 gallons of regular unleaded gasoline (9 gallons on the Hydroject® 4000) and should

operate the unit for approximately 4 hours. There is a fuel shut off valve located below the fuel tank and this

valve should be closed during periods of non-use.

NOTE: Take care in filling any fuel tank, and fill the tank to 1 inch below the top of the tank.

Always wipe up any spilled fuel to prevent a fire hazard.

The Fuel Filter should be replaced every 200 hrs.

Fuel Filter PN. 71-5960.

Toro Hydroject 3000 Troubleshooting Guide

Other manuals for Toro Hydroject 3000