EasyManuals Logo
Home>Toro>Lawn and Garden Equipment>Sitework Systems Dingo 322

Toro Sitework Systems Dingo 322 User Manual

Toro Sitework Systems Dingo 322
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
37
Troubleshooting
PROBLEM
POSSIBLE CAUSES
CORRECTIVE ACTION
Starter does not crank
1.
Auxiliary hydraulics lever is
not in neutral position.
2.
Battery is dead.
1.
Move lever to neutral
position.
2.
Charge the battery
.
3.
Electrical connections are
corroded or loose.
3.
Check electrical connections
for good contact.
4.
Relay or switch is defective.
4.
Contact Authorized Service
Dealer.
Engine will not start, starts hard, or
fil t k i
1.
Fuel tanks are empty
. 1.
Fill fuel tanks with gasoline.
g,,
fails to keep running.
2.
Choke is not on.
2.
Move choke lever fully
forward.
3.
Air cleaner is dirty
. 3.
Clean or replace air cleaner
element.
4.
Spark plug wires are loose or
disconnected.
4.
Install wires on spark plugs.
5.
Spark plugs are pitted, fouled,
or gap is incorrect.
5.
Install new
, correctly gapped
spark plugs.
6.
Dirt in fuel filter
. 6.
Replace fuel filter
.
7.
Dirt, water
, or stale fuel is in
fuel system.
7.
Contact Authorized Service
Dealer.
Engine loses power
.
1.
Engine load is excessive.
1.
Reduce ground speed.
gp
2.
Air cleaner is dirty
. 2.
Clean air cleaner element.
3.
Oil level in crankcase is low
. 3.
Add oil to crankcase.
4.
Cooling fins and air passages
under engine blower housing
are plugged.
4.
Remove obstruction from
cooling fins and air passages.
5.
Spark plugs are pitted, fouled,
or gap is incorrect.
5.
Install new
, correctly gapped
spark plugs.
6.
Dirt in fuel filter
. 6.
Replace fuel filter
.
7.
Dirt, water
, or stale fuel is in
fuel system.
7.
Contact Authorized Service
Dealer.
Engine overheats.
1.
Engine load is excessive.
1.
Reduce ground speed.
g
2.
Oil level in crankcase is low
. 2.
Add oil to crankcase.
3.
Cooling fins and air passages
under engine blower housing
are plugged.
3.
Remove obstruction from
cooling fins and air passages.
Abnormal vibration.
1.
Engine mounting bolts are
loose.
1. T
ighten engine mounting
bolts.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toro Sitework Systems Dingo 322 and is the answer not in the manual?

Toro Sitework Systems Dingo 322 Specifications

General IconGeneral
BrandToro
ModelSitework Systems Dingo 322
CategoryLawn and Garden Equipment
LanguageEnglish

Related product manuals