POWER
ENTER
EXIT/CANCEL
N
Press POWER on the unit or on the remote
control.
The POWER indicator on the front of the unit
changes to green. It may take approximately
10 seconds for a picture to appear on-screen.
POWER
POWER
R
The automatic channel search starts.
The TV/DVD will begin memorizing all the channels
available in your area.
If you want to stop the Automatic Search, press
EXIT/CANCEL. Only channels detected before the
cancellation will be stored.
After the Automatic Search is completed, the first
TV channel detected appears on the screen.
P
Press S or T to select “Signal Type”, then
press
W or X to select “Air” or “Cable”.
Q
Press S or T to select “Automatic Search”,
then press
X or ENTER.
Notes:
• The Auto Setup function is only available the first time
you turn on the TV/DVD.
• The Automatic Search process may take 15 to 30
minutes to complete, depending on your regional
cable service.
O
The Auto Setup menu appears on screen.
“Language” is automatically highlighted. Press
W or X to select your preferred language.
Auto Setup
The Auto Setup function helps to configure your TV/DVD for initial
operation. It lets you select the system language, the TV signal type,
and perform an automatic channel search.
Important: Make sure that the antenna or cable TV system connection
is made.
To Next Page
Loading...
Need help?
General
