27
English
Switching On
If the RED Stand By LED is unlit, check that the plug is connected to the power supply. If the picture
does not appear press on the remote control, it may take a few moments.
To put the television into Standby press
on the remote control. To view the television press
again. The picture may take a few seconds to appear.
For energy saving:
We recommend that you use the television with the factory settings. The factory settings are for
energy saving.
Unplugging the mains plug will cut energy use to zero for all televisions. This is recommended when
the television is not being used for a long time, e.g. when on holiday.
-
sumption and thus saves money by reducing electricity bills.
NOTE: Putting the television into standby mode will reduce energy consumption, but will still draw
some power.
Using the Remote Control
To set up the television you will now need to use the on screen menus. Press MENU on the remote
control to see the menus.
on the navigation ring on the remote control.
To use the options, press
move up and down through the menu and use to select the required choice. Follow the on-
screen instructions. The functions of each menu are described in detail throughout this manual.
Using the Side-Key Controls
Press to adjust volume.
Press
to change programme selection, then press to adjust programme selection.
Press and hold
until Source List is displayed, then press to scroll through the list until
desired input source is located.
7.9
NOTE: Inserting the headphone plug will mute the sound from all speakers.
To Next Page
Loading...
Need help?
General
