Unlocking programs temporarily
1. If you try to watch a TV program that exceeds the rating limits
_ou set, the TV enters into the program lock mode.
THIS PROGRAM HAS BEEN BLOCKED!
TV-PG L V
EXCEEDS SET LIMITS
PUSH MUTE TO ENTER PIN
CABLE 4
2. To temporarily unlock the program, press MUTE.
3. Press the Number buttons (0-9) to enter your 4-digit pin code.
BLOCKING ACTIVE
ENTER PIN CODE
TO TEMPORARILY UN-BLOCK
0-9:TO SELECT ENTER:TO SET
4. Press ENTER.
If the number is correct, the lock mode will be released and the
normal picture will appear.
All locking is disabled until the TV is turned off, and will be
enabled when the TV is turned on again.
Locking channels
With tile CH LOCK feature, you can lock specific channels. The TV
will not be able to tune locked channels with the Channel • •
buttons or Channel Number buttons, unless you clear the setting.
You can lock a maximum of nine channels.
To lock channels:
1. From the LOCKS menu, select CH LOCK. CH INPUT will be
highlighted.
2. Press • or • to display the CH LOCK menu.
3. Press the Channel Number buttons to enter the channel you
want to lock. (The channel you are currently watching cannot be
locked.)
4. Press ENTER.
®@®®@®
CLOCKS
V-CHIP
ENABLE BLOCKING OFF
TV RATING
MPAA RATING
VIDEO LOCK _ 0 0 0
FRONT PANEL LOCK 0 0 0
NEW PIN CODE 0 0 0
CLEAR AL_ v CABL_ii
®@®®@®
LOCKS
V-CHIP
ENABLE BLOCKING OFF
TV RATING
MPAA RATING
V I DEC LOCK 12 0
FRONT PANEL LOCK 0 0 0
NEW P I N CODE 0 0 0
TV CAr3L E
CLEAR ALL
5. Repeat steps 3 and 4 for other channels.
-- Number
MUTE
LOCKS menu
@@@©@®
O LOCKS
V-CHIP
ENABLE BLOCKING ON
TV RATING
MPAA RATING
FRONT PANEL LOCK OFF
NEW PIN CODE
To select each item:
Press • or •.
To Next Page
Loading...
Need help?
General
