33
EN
Introduction Connections Playback Editing OthersFunction SetupRecording VCR Functions
Basic Setup /
TV View Operation
• When the unit reaches the specified time, it will be
turned off automatically.
• To change the recording length during One-touch Timer
Recording, press [REC I] repeatedly until the desired
length appears.
• To cancel One-touch Timer Recording within the
specified time, press [STOP C].
9 Press [STOP C] to stop the recording.
This operation may take a few moments to complete.
Note
• You can change the channel while in the REC pause mode.
• Recording continues until the disc is full or you stop the
recording.
• If the clock is not set, the date and time of title names will be
01/01/10 and 00:00.
• You cannot change the recording mode in the REC or REC
pause mode.
• Even if the broadcasting you are recording is in the SECAM
system, this unit automatically converts it to the PAL system
when recording.
• Up to 99 titles can be recorded on the DVD-RW/-R discs.
• Up to 49 titles can be recorded on the DVD+RW/+R discs.
• You can play back a title on one component while making a
recording on the other component. To do so, simply select
the component (DVD or VCR) you want to use for the
playback by pressing [DVD] or [VCR] during DVD / VCR
recording. And then follow the normal playback procedure.
• NTSC recording is prohibited in this unit.
• The remaining recording time will appear on the TV screen
during One-touch Timer Recording. Press [DISPLAY] to see
it on the TV screen.
• The remaining recording time will be displayed on the front
panel display during One-touch Timer Recording.
• Unlike the timer recording, you can perform the following
operations during One-touch Timer Recording.
- Turn off the power. (One-touch timer recording will be
cancelled.)
-Use [REC I] or [STOP C] on the remote control.
• You cannot use the pause function during One-touch Timer
Recording.
• The unit will be turned off automatically under the following
conditions.
- No space remains on the disc.
- If a power failure occurs.
• If DVD One-touch Timer Recording is completed during
VCR playback or recording, the DVD will be in stop mode
and the VCR keeps the current mode.
• When One-touch Timer Recording is finished and the power
is turned off, the unit will switch to the timer-standby mode
automatically if a timer recording has been programmed.
Press [TIMER SET] to cancel the timer-standby mode to
use the unit continuously.
Timer Recording
You can set the unit to record up to 12 programmes, up to a
month in advance. Daily or weekly programme recordings are
also available.
• Be sure to set the clock before entering a timer
programming.
Insert a recordable disc or a tape with a record tab.
1 In stop mode, press [TIMER PROG.].
“Timer Programming” list will appear.
2 Select “New Programme” using [K \ L], then
press [ENTER\OK].
• If there are 6 programmes or more, use
[SKIP H \ G] to turn the page.
3 Enter the date using [K \ L], then press [1].
Each time you press [L] at the current date, the timer
recording date will change as follows.
e.g., 1st January
• Analogue channel is indicated as “ATV”.
4 Enter the time to start and to end using [K \ L],
then press [1].
DVB ANALOG
DVD-RW
To Next Page
Loading...
Need help?
General
