TROUBLESHOOTING AND MAINTENANCE
76
6
Close the front cover and
then the side cover by
pressing the round
projections near the side
cover open button. The error
indicator will go out and the
ready indicator will light up.
7
SCAN HEAD LOCKING SWITCH
The scan head locking switch is under the original table. If the switch is locked ( ),
the machine will not operate. Unlock the switch ( ) as shown below.
To lock the scan head locking switch, hold up the catch in illustration and turn the
center knob counter-clockwise 90 degrees until you hear a click.
When closing the covers, be sure to close the front cover securely and
then close the side cover. If the covers are closed in the wrong order,
the covers may be damaged.
Even after a new toner cartridge is installed, the start ( ) indicator
may not light up, indicating copying cannot be restarted (toner is not
sufficiently fed). In this case, open and close the side cover. The copier
will feed toner again approximately 2 minutes and then copying can be
restarted.
Caution
Note
Lock Unlock
Grasp here and turn in
the direction of the arrow.
A
A
Get other manuals https://www.bkmanuals.com
To Next Page
Loading...
Need help?
General