2 Installing Client Software
34 Repairing Client Software
Repairing Client Software
When the client software will not work correctly, you can repair the client software.
Repairing Client Utilities Software
The following describes an installation on Windows XP. The procedure is the same when other
versions of Windows are used.
y Do not perform preparing the client software on Windows XP that the Service Pack 2 is not
installed. In that case, uninstall the client software and then install again to repair the client
software.
y Before repairing the software, please make sure you exit TopAccessDocMon and e-BRIDGE
Viewer.
1
Insert the Client Utilities CD-ROM into the CD-ROM drive.
y If the installer does not automatically start, double-click “Setup.exe” in the Client Utili-
ties CD-ROM.
2
Select “Repair” and click [Next].
y Repairing files starts.
If the printer drivers and N/W-Fax driver are installed, the Select Port screen is displayed.
If this screen is displayed, select “Local Port” and select the port for the printer drivers if
printer drivers were installed. If this screen is displayed, specify the network path or
queue name and click [Next].
To Next Page
Loading...
Need help?
General
