1. Click Power in the Settings charm, and then click Shut down while
holding down the SHIFT key - ensure that the Power indicator is off.
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down.
4.
Slide your fingernails or thin objects under the cover and lift the whole
back on to open the large cover, then you can access the memory
modules.
5. Push the latches away from the module in order to release it - a spring
will force one end of the module up at an angle.
6. Grasp the module by its edges and remove it from the computer.
If you use the computer for a long time, the memory modules and the
circuits locating close to the memory modules will become hot. In this
case, let them cool to room temperature before you replace them. Or
you will get burnt if you touch any of them.
Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
Figure 4-17 Removing the memory module
1. Latches
Product appearance depends on the model you purchased.
7.
Seat the back cover in place.
Take care to ensure that the cover is firmly closed.
8. Turn the computer over.
Memory media
The computer is equipped with a memory media slot that can
accommodate some kinds of memory media with various memory
capacities so that you can easily transfer data from devices, such as digital
cameras and Personal Digital Assistants.
User's Manual 4-35
To Next Page
Loading...
Need help?
General