Toshiba TC-net 100 Installation And Wiring Manual

14 TC-net 100 Installation and Wiring Manual
Chapter 3 TC-net 100 Cabling (Twisted-Pair Cable)
3
Handling Cables with Connector
Observe the following in handling the individual cables (UTP and STP cables) to which a
connector has been attached.
• Before wiring, check the wiring routes and the spaces for passing the connectors
through, and determine the required cable length. If extra cable length is expected,
study ways of processing it in advance.
• To reattach a connector to a cable, cut a cable end and fix a new connector to that
cable end.
• Till the time of cable installation, keep the connectors covered with a vinyl sheet or a
thick sheet of cloth to protect them from damage. Also exercise care to keep the
connectors free of dust and dirt.
Category 5 UTP cable with
RJ45 connector at both ends
Relay connector unit
TC-net 100 module
Category 5 STP cable with RJ45
modular connector at both ends
TC-net 100 module
Category 5 UTP cable with RJ45
connector at both ends
Ferrite core (Attach it to station.)
Cabinet
C
ategory 5 UTP cable with RJ45
connector at both ends
Cabinet
TC-net 100 module
Cabinet
< 100m
<
3
0m

Toshiba TC-net 100 Specifications

General

Brand	Toshiba
Model	TC-net 100
Category	Network Hardware
Language	English