7-6 User’s Manual
TECRA A9, TECRA S5, Satellite Pro S200, Satellite Pro A150
LAN
Wake-up on LAN
This feature lets the computer’s power be turned on when it receives a
wake-up signal from the LAN.
Power will be automatically turned on when a signal is received from an
administrator’s computer which is connected via a network.
The following settings can be changed when the Built-in LAN is Enabled.
Connect the AC adaptor when using the Wake-up on LAN function. The
battery retention time will be shorter than the times listed in this manual
when this function is enabled. Refer to the section in Chapter 6, Retaining
data with power off.
Built-in LAN
This feature enables or disables the Built-in LAN.
Dynamically
Switchable
The processor’s power consumption and
automatic clock speed switching functions are
enabled - in use the processor’s operation is
automatically switched when necessary (default).
Always High The processor’s power consumption and
automatic clock speed switching functions are
disabled - in use the processor will always run at
its highest level of power consumption and its
highest speed.
Always Low The processor’s power consumption and
automatic clock speed switching functions are
disabled - in use the processor will always run at
a lower level of power consumption and a low
speed.
Do not install or remove a memory module while Wake-up on LAN is
enabled.
The Wake-up on LAN function consumes power even when the system is
off. Leave the AC adaptor connected while using this feature.
Enabled Enables Wake-up on LAN.
Disabled Disables Wake-up on LAN (Default).
Enabled Enables Built-in LAN functions (Default).
Disabled Disables Built-in LAN functions.
To Next Page
Loading...
Need help?
General