OPERATOR’S MANUAL
series Robot Controller
1.3.4 Repeating an Entry
The repeat function allows entry of repeated operation by pressing the same key
continuously.
The following keys are available for the repeat operation.
• Cursor keys (The keys can be moved rapidly by the repeat function.)
• Guide keys (A selected axis moves continuously as long as this key is kept
pressed.)
• MOVE key (A selected axis moves continuously as long as this key is kept
pressed.)
1.3.5 Correcting Incorrect Entries
Use the BS key to erase any characters which were incorrectly entered.
Example:
(Correct) OVERRIDE: 80 (Incorrect) OVERRIDE: 65__
Press the BS key. ↓
OVERRIDE: 6__
Press the BS key. ↓
OVERRIDE: __
Keep pressing the BS key until the incorrect characters are erased. Then try again.
* In the editor operation, press the BS key while pressing the ALT key, and a
character at the cursor position is erased. It functions the same way as the
DEL key.
!
CAUTION
The INS, ↑, ↓, ←, → keys cannot be used at the time of command input.
STE 80720
– 1-12 –
To Next Page
Loading...
Need help?
General
