Toto Washlet SG User Manual

52 53
What to Do? What to Do?
Freeze Damage Prevention
When the ambient temperature is likely to drop to 0°C or lower, take measures to prevent freezing.
Attention!
●
When the ambient temperature is likely to drop to 0°C or lower, do not use the energy saver feature.
(May damage the product.)
●
Warm the bathroom or take measures against freeze so that the ambient temperature does not drop below 0°C.
●
Before starting work, set "AUTO OPEN/CLOSE" (Page 42) to "OFF".
Anti freezing
■
How to drain the water
1
Close the shutoff valve.
2
Drain the pipe.
(1) Extend the wand.
•
Operate with the buttons on the back
side of the remote control.
1. Press [MENU].
2.
Use
to select [CLEANING].
Press [ENTER].
3.
Use
to select [WAND
CLEANING MODE ON/OFF].
Press [ENTER] to extend the wand.
•
Hold the wand in the extended
position until no more water comes
from around the wand.
Press [ENTER] again to retract the wand.
(Release the pressure from the
water supply pipe.)
(2)
Unplug the power plug. (Page 15)
Switch the breaker on the distribution board
to OFF. (Concealed power connection type)
(3) Remove the cover and water fi lter
drain valve.
Cover
Water filter
drain valve
(4) After draining the water, install the
water fi lter drain valve and cover.
•
Insert the water fi lter drain valve and
use a fl at-head screwdriver to tighten
it securely.
Cover
(5) Insert the power plug. (Page 15)
Switch the breaker on the distribution
board to ON.
(Concealed power connection type)
3
Check that the POWER LED
on the main display is lit up.
(Page 15)
4
Set the toilet seat temperature
to "High".
(Page 24)
(To maintain the temperature.)
•
When fi nished, close the toilet seat and toilet
lid.
■
To use the Washlet again
•
The water needs to be resupplied.(Page 54)
If you cannot operate with the remote control
■
Operation is also possible using the
buttons on the control panel.
Control panel
■
The batteries may have worn out.
Replace the batteries.
■
Replacing the batteries
1
Press [POWER ON/OFF] on the control panel.
•
The POWER LED goes off.
2
Remove the remote control from the hanger.
(Page 14)
POWER LED
3
Open the cover and replace the AA
batteries.
(Page 14)
4
Mount the remote control in the hanger.
5
Press [POWER ON/OFF] on the control panel.
•
The POWER LED lights up.
Reference

Toto Washlet SG Specifications

General

Brand	Toto
Model	Washlet SG
Category	Toilets
Language	English