54 55
Troubleshooting
First, try the actions described on pages 55 to 60. If the
problem persists, consult the installer, seller or the contact
listed on the back cover of this manual.
●
The CLEAN indicator does not light up
(It is time for parts replacement.➝Page 60)
CAUTION
If a water leak occurs, close the shutoff
valve.
Please check fi rst
Is the POWER LED lit?
■
Does the LED light up
when you press [POWER
ON/OFF] on the main unit?
■
Is the breaker on the
distribution board turned
on?
➞
Check whether there is a power
outage or the breaker has turned
"OFF".
POWER LED
POWER ON/OFF
Is the
ENERGY SAVER LED
lit?
■
While the LED is lit, energy saver
(Page 26)
is in operation,
so the toilet seat temperature may be reduced or the
heater may be turned off.
Is the
remote control
working?
■
Are the remote control
batteries dead?
➞
Replace the batteries. (Page 52)
■
Is the remote control
transmitter or the remote
control receiver blocked?
➞
Remove obstructions, dirt, water
droplets or any other blockages.
Battery cover
Close
Open
The remote
control uses
batteries to
operate.
Remote control
transmitter
Remote control
receiver
Resupplying the Water (After draining)
1
Open the shutoff valve.
Check that water is not leaking from a
pipe or the main unit.
2
If the power is not turned ON
Insert the power plug.
(Page 15)
Switch the breaker on the
distribution board to ON.
(Concealed power connection type)
3
Discharge water from the
wand.
(1) Pressing down the left side of the
toilet seat,
(2)
Press the [REAR] on the remote control
to discharge water from the wand.
(Catch the water in a paper cup or
other receptacle)
■
If the remaining water has
frozen and no water comes out
•
Heat the inside of the bathroom, and
warm the water supply hose and shutoff
valve using a cloth soaked in warm water.
How to drain the water
1
Close the shutoff valve.
(Page 55)
2
Drain the pipe.
(Step
2
(1) to (4) on Page 53)
3
Pull out the water
drain lever.
•
The water comes out from
near the wand for about
20 seconds.
4
Release your hand
to return the water
drain lever to its
original position.
■
If water may get frozen
•
Add antifreeze solution in the water in the bowl to prevent
freezing.
(The antifreeze solution should not be fl ushed out. Collect
it before using the toilet and dispose of it.)
■
To use the Washlet again
•
The water needs to be resupplied.(See right)
If the toilet is in a location you will not visit for a long time, drain the water.
(The water in the tank may become contaminated and cause skin irritation or other problems.)
What to Do?
Long Periods of Disuse
Reference
To Next Page
Loading...
Need help?
General