BMTK-SVN01D-EN 43
Chapter 5
Display module mounting
After mounting the main module, attach the display module to the main
module
.
This chapter provides information and procedures that enable
you to mount the display module.
1. Tilt the top of the display module about 30 degrees toward you.
2. Line up the three tabs on the bottom of the display module with the
slots on the bottom of the main module (Figure 22 on page 44).
3. Starting with the center tab, insert the tabs into the slots.
CAUTION
Avoid Equipment Damage!
Do not use excessive force when mounting the module. If the module
does not snap easily into place, slightly reposition it on the alignment
pins. Failure to comply may cause damage to the module.
4. Push the top of the display module toward the main module until it
snaps into place while making sure that the tabs on the display mod-
ule engage the slots on the main module (Figure 23 on page 45). If 24
Vac power is applied to the Tracker controller, the display module will
turn on and display information.
Note:
The Tracker controller ships with the display module
assembled to the main module. If those two modules are
assembled, you need only to perform the main module
mounting procedure (Chapter 4, “Main module mounting”).
Note:
It is not necessary to turn off 24 Vac power to the Tracker
controller prior to mounting or removing the display module.
To Next Page
Loading...
Need help?
General
