28 BAS-SVX40A-EN
Appendix: Using the Tracer™ TU Service Tool with Wireless Networks
3. On the right side of the Startup Task Panel, select TU Adapter - Wireless and then click the
Connect button. The Wireless Network Utilities screen appears (
Figure 15) showing the group
and subnetwork numbers (which correspond to WCI address settings; see “WCI Addressing,”
p. 10), and signal strength for all existing wireless networks within radio range of Tracer TU.
Figure 15. Wireless Network Utilities
4. Select the network you want Tracer TU to join. Click the Join button.
Note: Tracer TU can join only one network at a time.
5. If a Tracer SC is present on the network, a log-in prompt appears. Enter your ID and password.
After log-in, the Wireless Network Utilities screen appears as shown in Figure 16.
Note: If no Tracer SC is present on the network, the screen shown in Figure 16 appears without
the need to log in.
In the Security column, the lock icon is replaced by a key icon to identify the network that Tracer
TU has joined, and two additional tabs appear on the screen.
Figure 16. Wireless Network Utilities screen after joining the network
To Next Page
Loading...
Need help?
General
