Trane Wireless Comm User Manual

BAS-SVX40A-EN 31
Appendix: Using the Tracer™ TU Service Tool with Wireless Networks
• Open Network: Select to allow a new member to join. Any WCI with a correct rotary address
setting that is located within radio range of the open network will join the network. (Similar to
OPEN_NET button on WCI.)
• Close Network: Select to prevent new members from joining the network.
• Exit Network: Select to remove the attached device from the network. Only available when TU
is attached to a unit controller that belongs to the network.
• Disband Network: Select to disband the network.
Note: Tracer TU must be attached to the network coordinator.
• Join Network: Select to join the network.
• Create Network: Select to create a new network in which the attached device will be network
coordinator. (Similar to START button on WCI.)
Note: Typically, used for a unit controller that will be network coordinator when no Tracer SC
is present.
• Advanced: Opens the Advanced tab (see Figure 21).
Figure 20. Network Details tab
Figure 21. Wireless Sensor Status tab

Trane Wireless Comm Specifications

General

Brand	Trane
Model	Wireless Comm
Category	Control Unit
Language	English