E
ConnectHoseandWater Supply to Pump
I NOTICE
DONOTrun the pump without the water supply connected
and turned on==:=._ _ m
• Damageto equipmentresultingfromfailureto followthis
instructionwill voidwarranty.
NOTE:Removeand discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1. Uncoil high pressure hoseand attach one end of hose
to baseof spray gun. Tighten by hand.
WARNING
The high pressure stream of water that this
_ quipment produces can cut through skin and its
underlying tissues, leading to serious injury and
)ossible amputation.
= NEVERconnect high pressure hose to nozzleextension.
= Keep high pressure hose connectedto pump and spray gun
while system is pressurized.
= Always be certain spray gun, nozzlesand accessoriesare
correctly attached.
2. Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
3. Beforeconnecting garden hoseto water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or
haveit replacedif damaged.DO NOTrun pressure
washer if inlet screen is damaged.
4. Run water through your garden hosefor 30 secondsto
cleanout anydebris.
iMPORTANT:DO NOTsiphon standing water for the water
supply. UseONLY cold water (less than 100°F (38°C)).
5. Connectthe garden hose (not to exceed50 feet (15 m)
in length) to the water inlet. Tighten by hand.
NOTICE
Using a One Way Valve (vacuum breaker or check valve)
at pump inlet can cause pump or inlet connector damage.
= ThereMUST beat leastten feet (3 m) of unrestricted garden
hose betweenthe pressure washer inlet and any device, such as
a vacuum breakeror checkvalve.
= Damageto equipment resulting from failure to follow this
instruction will void warranty.
6. Turn ONthe water and squeezethe trigger on the spray
gun to purge the pump system of air and impurities.
WARNING
>_ Risk of eye injury.
" Spray can splash back or propel objects.
• Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressurewasher, besure you are wearing
adequatesafety goggles.
• NEVERsubstitute safety glassesfor safety goggles.
Checklist Before Starting Engine
Reviewthe unit's assembly to ensure you have performed all
of the following.
1. Be sure to readthe Operator Safety section and How to
Use Your Pressure Washerin Operation section before
using pressurewasher.
2. Make sure handle is in placeand secure.
3. Checkthat oil hasbeen addedto proper level in the
engine crankcase.
4. Add proper fuel to fuel tank.
5. Checkfor properly tightened hoseconnections.
6. Checkto make sure there are no kinks, cuts, or damage
to high pressure hose.
7. Provide a proper water supply at an adequateflow.
10 www.troybiit.corn
To Next Page
Loading...
Need help?
General
