- 44 -
7.4 Sensor
This option is used to calibrate the selected sensor. We recommend calibrate the sensor
before printing when changing the media.
This option is used to set the media sensor type and
calibrate the selected sensor automatically. Printer will feed
2 to 3 gap labels to calibrate the sensor sensitivity
automatically.
In case “Automatic” cannot apply to the media, please use
“Manual” function to set the paper length and gap/bline size
then scan the backing/mark to calibrate the sensor
sensitivity.
Note: The “Media Capacity” item is used to calibrate the
media capacity sensor %.
This option is used to set sensor sensitivity in fixed or auto.
This option is used to set the maximum length for label
calibration.
This option is used to set upper or lower black mark sensor
as the main transmitter.
Enable pop up the error when opening the media cover
This function can set the minimum paper length and
maximum gap/bline length for auto-calibrate the sensor
sensitivity.
Menu Sensor
Auto
Calibration
Gap
Black Mark
Continuous
Preprint
Manual
Calibration
Standard
Gap
Black Mark
Continuous
Threshold
Detect
Auto
Fixed
Maximum
Length
BMark
Transmitter
Back side
Front side
Cover Error
Advanced
Min. Paper
Max. Gap/Mark
To Next Page
Loading...
Need help?
General
