TSC AUTO ID Technology Co., Ltd. 6 Copyright 2009 All Rights Reserved.
BLINEDETECT
Description
This command feeds the paper through the black mark sensor in an effort to determine the
paper and black mark sizes, respectively. This command references the user’s approximate
measurements. If the measurements conflict with the actual size, the BLINEDETECT
command will not work properly. This calibration method can be applied to the labels with
pre-printed logos or texts.
Syntax
BLINEDETECT [x, y]
Parameter Description
x Paper length (in dots)
y Gap length (in dots)
Note: If the x, y parameters are ignored then the printer will calibrate and
determine the paper length and gap size automatically.
See Also
GAP, SIZE, GAPDETECT, AUTODETECT
To Next Page
Loading...
Need help?
General
