TSC AUTO ID Technology Co., Ltd. 156 Copyright 2009 All Rights Reserved.
SET TEAR & SET STRIPER
Description
This command is used to enable/disable feeding of labels to gap/black mark position for
tearing off. This setting will be saved in printer memory when turning off the power.
Syntax
SET TEAR ON/OFF (TSPL2 language printers only)
SET STRIPER ON/OFF (TSPL language printers only)
Parameter Description
ON The label gap will stop at the tear off position after print.
OFF The label gap will NOT stop at the tear off position after print. The
beginning of label will be aligned to print head.
To Next Page
Loading...
Need help?
General
