INSTALLATION, SPECIFICATIONS, AND MAINTENANCE
5
DAILY MAINTENANCE FOR THE NGC
Before cleaning, check with the store for custom
cleaning instructions.
When cleaning the oven, use only TurboChef Oven
Cleaner.
Any other cleaning products can damage
critical parts and may void warranty on those parts.
Supplies and Equipment
TurboChef
®
Oven Cleaner (P/N 103180 USA,
103380 Intl), Oven Guard (P/N 103181 USA,
103381 Intl), nylon scrub pad, cleaning towel
Step 1: Prepare the Oven
o
Turn oven off by pressing the BACK key.
o
The oven will display OVEN OFF/COOLING DOWN.
o
x
DO NOT attempt to clean oven during the cool
down cycle. Cooling takes appx. 90 minutes.
WARNING
: The oven operates at appx. 500
º
F
(260
º
C) and may cause injury if not allowed
time to cool properly.
Step 2: Remove the Lower Access Panel
o
Wipe out any crumbs that have collected.
Step 3: Remove and Clean the Cooking Surface
o
If rack, wash, rinse, and sanitize.
o
If baking stone,
gently dry-scrub with nylon pad.
If the stone gets wet, let it thoroughly air-dry.
Step 4: Lift Bottom Element
o
Be sure the bottom element is cool prior to lifting.
WARNING
: The bottom element operates at
appx. 1000
º
F (537
º
C).
Step 5: Remove Particles and Spray Oven Interior
with
TurboChef
®
Oven Cleaner
o
Using a damp towel, remove large food particles.
o
If stubborn stain is present, sparingly spray
TurboChef Oven Cleaner onto the stain.
o
Allow cleaner to penetrate for five (5) minutes.
o
x
DO NOT saturate the bottom of the oven with
water or oven cleaner.
Step 6: Clean Oven Interior
o
Using a nylon scrub pad, clean the oven door
and cook cavity.
CAUTION: DO NOT apply pressure to the
wave guide covers. Breaking will result in a
non-warranty service call.
Step 7: Wipe Out Oven Interior
o
Wipe oven door, bottom element, and cook
cavity using a damp towel.
Step 8: Clean Lower Access Panel Area
o
x
DO
NOT
spray any chemical in this area.
Step 9: Lower the Bottom Element and Reinstall the
Cooking Surface and Lower Access Panel
Step 10: Apply Oven Guard and Clean Oven Exterior
o
Spray Oven Guard on towel. Wipe sides of cook
cavity and inside of door.
o
x
DO NOT spray Oven Guard directly into cook
cavity or wipe on nozzle plates/bottom element.
o
Wipe the oven exterior with a clean, damp towel.
o
Oven is ready to turn on.