MAX-M10M-Integration manual
Pin no. Name PIO no. I/O Description Remarks
15 VIO_SEL - I Voltage selector for
V_IO supply
Connect to GND for 1.8 V supply, or leave open for 3.3
V supply
16 SDA 2 I/O I2C data
If not used, leave open. Alternative functions
1
.
17 SCL 3 I I2C clock
If not used, leave open. Alternative functions
1
.
18 SAFEBOOT_N - I Safeboot mode
To enter safeboot mode, set this pin to low at receiver's
startup. Otherwise, leave it open.
The SAFEBOOT_N pin is internally connected to
TIMEPULSE pin through a 1 kΩ series resistor.
Table 1: MAX-M10M pin assignment
UBX-22038241 - R02
1 System description Page 8 of 92
C1-Public
To Next Page
Loading...
Need help?
General
