14 GB/IE/NI/CY/MT
compressor is not started or if no
consumables are connected.
z Check the charge level
of the power bank
with compressor
Switch on the power bank with
compressor
1
by using the switch
for the power bank
9
.
During charging, the indicator
lights will flash
13
.
The number of permanently lit
indicator lights
13
shows the
charge level of the power bank
with compressor
1
.
If the device is fully charged, all
four indicator lights
13
will be
permanently lit.
Indicator lights Charge level
0 permanently lit 0%
1 permanently lit 25%
2 permanently lit 50%
3 permanently lit 75%
4 permanently lit 100%
z Charging the power
bank with compressor
Connect the power bank with
compressor
1
to a socket using
the AC adapter
24
.
To do so, plug the cable from the
AC adapter
24
into the charging
port (5 V
/2 A)
10
on the
power bank with compressor
1
and then plug into a mains power
socket.
Attention: Only use the AC
adapter as supplied
24
with the
device!
Note: An undervoltage protection
circuit is installed in the power bank
with compressor
1
to protect the
device from damage. This prevents
a deep discharge of the power bank
with compressor
1
and automati-
cally switches the device off once
the battery is fully discharged. In this
case, only one of the four
blue indicator lights will be lit
13
.
In this case, no more energy can
be obtained and the compressor
function will be deactivated. Please
recharge the power bank with com-
pressor
1
using an AC adapter
24
.
z Charging mobile
phones and tablets
Press the power switch for the
power bank with compressor
9
once.
Connect a suitable USB
charging cable to the USB port
(5V
/2A)
11
or the USB port
(5V
/1A)
12
and then plug it
into your mobile phone or tablet.
The charging process starts
automatically.
To Next Page
Loading...
Need help?
General
