18 GB/IE/NI/CY/MT
Safety fuse
If the device becomes overloaded or
malfunctions, the safety fuse triggers
to protect the device.
Never use a fuse with a
higher release current
strength. There is a risk
of fire!
Attention: To protect people and
property, an overheat protection
circuit has been installed for the
battery in the power bank with
compressor
1
. This prevents an
overheating of the battery installed
in the device and automatically
switches off the power bank with
compressor
1
if the battery temper-
ature is too high. If this happens,
allow the device to cool down prior
to re-commissioning it.
z Switch on lighting
Light mode
To switch on the LED light
7
,
press the power bank switch
9
for 3 seconds.
Press the power bank switch
9
for another 3 seconds in order to
switch the LED light
7
back off.
Flash mode
To switch on the LED light
7
in
the flash or SOS mode, first press
the power bank switch
9
for
3seconds. Then the LED light
7
will be permanently lit.
Briefly press the power bank
switch
9
once again and the LED
light
7
will switch to flash mode.
Briefly press the power bank
switch
9
once again and the LED
light
7
will switch to SOS mode.
There will be 3 short flashes,
3long flashes and another
3short flashes.
Briefly press the power bank
switch
9
once again to switch
off the LED light
7
.
Caution! Do not look
directly at the LED lights
7
as
this can damage your eyes.
Note: It is not possible to turn on
the light while the power bank with
compressor
1
is charging.
z Using the jumpstart
feature
When using the jumpstart,
make sure that at least 3 indica-
tor lights
13
are permanently
illuminated.
1
To Next Page
Loading...
Need help?
General
