UNI-T UT203 User Manual

D. Testing for Continuity (see figure 6)
(figure 6)
Red Black
Warning
To avoid damages to the Meter or to the devices
under test, disconnect circuit power and discharge
all the high-voltage capacitors before measuring
continuity.
To test for continuity, connect the Meter as follows:
Insert the red test lead into the Hz Duty%
terminal and the black test lead into the
COM terminal.
Set the rotary switch to and press SELECT
button to select measurement mode.
The buzzer sounds if the resistance of a circuit
under test is less than 50
1.
2.
3.
4.
5.
The buzzer may or may not sounds if the resistance of a circuit under test is
between 50 to 100
The buzzer does not sound if the resistance of a circuit under test is higher than
100
Model UT203/204: OPERATING MANUAL
24

UNI-T UT203 Specifications

General

Frequency range	0.01 - 1000 kHz
AC current range	40 - 400 A
AC voltage range	4 - 600 V
Continuity check	Yes
DC voltage range	0.4 - 600 V
Basic accuracy (frequency)	±(0.1%+3)
Basic accuracy (DC current)	±(2%+3)
Basic accuracy (DC voltage)	±(0.8%+1)
Basic accuracy (resistance)	±(1%+2)
Dimensions (WxDxH)	76 x 30 x 210 mm
Battery voltage	9 V

Weight and Dimensions

Weight	200 g