Measurement Operation(1)
A. DC Voltage Measurement (see figure 3)
Warning
To avoid harms to you or damages to the Meter from
electric shock, please do not attempt to measure
voltages higher than 1000V or 750V rms although
readings may be obtained.
The DC Voltage ranges are: 200mV, 2V, 20V, 200V and
1000V. To measure DC voltage, connect the Meter as
follows:
( figure 3)
13
1. Insert the red test lead into the VΩ input terminal
and the black test lead into the COM input terminal.
2. Set the rotary switch to an appropriate measurement
position in V range.
3. Connect the test leads across with the object being
measured.
The measured value shows on the display.
l Make sure the Sleep Mode is not on if you found
there is no display on the LCD after turning on the
Meter.
l Make sure the Low Battery Display is not on, otherwise
false readings may be provided.
l Pay extra attention to the
symbol which is located
besides the input terminals of the Meter before carrying
out measeurement.
red black
Model UT50A/B/C: OPERATING MANUAL
To Next Page
Loading...
Need help?
General
