45
Model UT804: OPERATING MANUAL
Note
l
l
l
l
When the measured current is 5A, continuous
measurement is allowed.
When the measured current is between 5A-10A,
continuous measurement 10 seconds and interval
more than 15 minutes.
Do not attempt to measure higher than 10A.
When measurement has been completed, disconnect
the connection between the testing leads and the
circuit under test and remove the test leads away
from the input terminals.
3. When the readings obtained is:
l < 4mA, the primary display shows LO
l 4mA, the primary display shows 0%. ….
l 20mA, the primary display shows 100%
l > 20mA, the primary display shows HI
To Next Page
Loading...
Need help?
General
