UNI-T UT804 User Manual

48
Model UT804: OPERATING MANUAL
Introduction
The Meter allows you to change the default operating configuration of the Meter by changing setup options made at
the factory.
These settings are stored and can be changed in the Setup mode using the procedure described in this chapter.
Selecting Setup Options
To enter the Setup mode, turn the Meter on and press the SETUP button. It is recommended to change the default
setting only when the Meter is at DCV measurement mode.
In the Setup mode, each press of SETUP button steps to the next Selection. Each press of – or + button decrement
or increment an Option.
Each Setup Selection and Option appears in the primary display in the sequence shown in Table 5-1.
Chapter 5
Changing the Default Setting

UNI-T UT804 Specifications

General

Brand	UNI-T
Model	UT804
Category	Multimeter
Language	English