UNI-T UTG2122B User Manual

106 UTG2000B Series
Figure 3 -53 Select waveform of pulse train
You can set amplitude with multi-functional knob and direction key (note: if frequency is displayed,
only frequency can be set, which means that conversion between frequency and period cannot be
realized. If frequency is displayed, period of 2ms is corresponding to frequency of 500Hz. They are
reciprocal, i.e. T=1/f). You can also press soft function
key Param → Freq →
Freq again (press the soft key Freq twice for conversion between
frequency and period in parameter list), when the interface below will pop up.To set some
parameter, press corresponding soft key, input the required value and select the unit.
Figure 3 -54 Set waveform amplitude
Set period of pulse train and recurring number of waveform
Press soft function key RETURN to return to the interface below after selecting waveform of pulse
train and relevant parameters:

UNI-T UTG2122B Specifications

General

Brand	UNI-T
Model	UTG2122B
Category	Portable Generator
Language	English