79
Gigaset S850 / ALL UK en / A31008-XXXXX-XXXX-X-XX / starting.fm / 12/2/14
Template Go, Version 1, 01.07.2014 / ModuleVersion 1.0
Getting started
DeutschEnglish
Charging the batteries
¤ Charge the batteries fully prior to first use in the
base station/charging cradle or using a standard
USB mains adapter (
p. 80).
The batteries are fully charged when the power icon
disappears from the display.
Attaching the belt clip
The handset has notches on each side for attaching the belt clip.
• Attaching the belt clip: Press the belt clip onto the back of the
handset so that the tabs on the belt clip click into place in the
notches.
• Removing the belt clip: Press the centre of the belt clip firmly
with your right thumb. Push the nail of your left thumb up
between the clip and the casing. Slide the clip upwards to
remove.
Setting up the telephone for use
Changing the display language
You can change the display language, if the telephone has been set to an incomprehensible
language.
¤ Press middle of the control key .
¤ Press the keys and slowly and successively . . . the
language settings display appears, the set language
(e.g.English) is highlighted ( = selected).
¤ Select different language: Press the control key until the
desired language is marked in the display, e. g. French press
the key on the right directly underneath the display to activate the language.
¤ To revert to idle status: Press and hold the End call key
The handset may only be placed in the designated base station or charging cradle.
The battery may heat up during charging. This is not dangerous.
After a time, the charge capacity of the battery will decrease for technical reasons.
Handsets contained in the package have already been registered to the base station.
In the event that a handset is not registered however, (indicated by "Please register
handset"), register the handset manually ( p. 108).
To Next Page
Loading...
Need help?
General
