Description
LED Indications
Management Mini-USB port for device management, see Accessing Wireless Service
Gateway WSG on page 22.
Mode button The Mode button is a momentary push button with a blue LED. Used for plac-
ing the module into specific modes by different push patterns.
Restart button The Restart button is a hole button that requires a paper clip (or similar) to be
able to push. Used for performing controlled restart and forced restart, see
Restarting the Wireless Service Gateway WSG on page 37.
SD card slot Currently not used (for future releases)
Rear side
LAN1 Modular jacks (RJ45) for connection of 10baseT or 100baseT Ethernet TCP/
IP network, see Ethernet Ports on page 21.
LAN2 Currently not used (for future releases)
V+ Ext/GND Ext External 12 V power supply to provide galvanic isolation of the inputs and out-
puts, see below.
In1/In2 and
Out1/Out2
Connects AUX Inputs and
AUX Outputs, see Connection of AUX Inputs and AUX Outputs on page
22.
Error Connector where an error relay output is available, see Error Relay Output on
page 21.
12-24 V DC Connection for external backup battery/power supply, see Supply Voltage on
page 19
100-240 V AC Connection of supply voltage, see Supply Voltage on page 19
LED Indications
The LEDs show different colors to determine type of information and have different flashing fre-
quency for showing the priority
.
Colors
Red Fault indication
Yellow Mode indication
Blue Normal operation (OK)
A31003-M2000-J109-01-7631, 30/06/2020
Wireless Service Gateway WSG, Installation Guide 11
To Next Page
Loading...
Need help?
General