-15- © 2017 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS650 User’s Manual
2.3 Power Off Timeout
2.3.1 Variable Timeout
The timeout is 30 seconds by default, and is programmable to the second
and minute, ranging from 10 seconds (00:10) to 60minutes and 60
seconds (60:60)
For example, to set the timeout as 5 minutes 30 seconds:
1. Scan [Set Minute]
2. Scan [0] & [5] on below numeric barcode table.
3. Scan [Set Minute]
4. Scan [Set Second]
5. Scan [3] & [0] on below numeric barcode table.
6. Scan [Set Second]
Set Minute
(Range: 00~ 60)
Set Second
(Range: 00~ 60)
Disable Time out
(Scanner always On)
Note: This will cause the battery to drain quickly.
To Next Page
Loading...
Need help?
General
