-44- © 2017 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS650 User’s Manual
Chapter 4 – Command Settings
4.1 General setting
4.1.1 Default
Scan below bar code to restore the factory setting.
4.1.2 Check Version
Scan below bar code to check firmware version.
4.1.3 Reset / Abort
Scan below bar code to abort multi-step configuration.
4.1.3 Setup Code Read
Scan below bar code to set up code read.
Setup Code On
Setup Code Off
Caution:
Scanning SETUP CODE OFF will turn the scanner into unprogrammable
state and the scanner will not react to any configuration barcode!
To Next Page
Loading...
Need help?
General
