Suppress Power-up Beeps
Select whether or not to suppress the digital scanner’s power-up beeps.
Beeper Duration
To select the duration for the beeper, scan one of the following bar codes.
Trigger Modes
Select one of the following trigger modes for the digital scanner:
Standard (Level) - A trigger pull activates decode processing. Decode
processing continues until the bar code decodes, you release the trigger, or the
Decode Session Timeout occurs.
Presentation (Blink) - The digital scanner activates decode processing when
it detects a bar code in its field of view. After a period of non-use, the digital
scanner enters a low power mode, in which the LEDs turn off until the digital
scanner senses motion.
Host - A host command issues the triggering signal. The decoder interprets an
actual trigger pull as a Level triggering option.
Auto Aim - This trigger mode turns on the LED aiming dot when the scanner is
lifted. A trigger pull activates decode processing. After 2 seconds of inactivity
the aiming pattern shuts off.
Auto Aim with Illumination - This trigger mode turns on the aiming pattern
and internal illumination LEDs when the decoder senses motion. A trigger pull
activates decode processing. After 2 seconds of inactivity the aiming pattern
and internal illumination LEDs automatically shut off.
*Standard (Level)
34
Copyright 2013 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
