4948
A maximum of 8 devices can be paired to the
uDirect 2. Another pairing will replace the first
device that was paired.
The uDirect 2 can support (connect) two phones
at the same time but only one call at a time is
possible.
For more information about Bluetooth pairing
instructions specific to some of the most popular
manufacturers, go to:
www.unitron.com
1. Turn ON your uDirect 2 and the phone. Place
them next to each other.
2. Locate the connectivity settings in your phone
menu. Look for the Bluetooth feature.
3. On your phone, ensure that the Bluetooth
feature is turned on.
4. On your phone, choose SEARCH to search for
Bluetooth devices or audio enhancements.
5. To initiate the pairing process on your
uDirect 2, press and hold the (
) and ( )
buttons simultaneously for 2 seconds until
blue blinking audio indicator.
Most Bluetooth devices perform the
connection procedure automatically after
pairing.
The pairing and the connecting procedures are
described on the following pages.
Setting up Bluetooth
This section describes the pairing and
connection procedure for Bluetooth devices.
Step-by-step: pairing a Bluetooth-enabled
phone
It is only necessary to perform the pairing
procedure once with each Bluetooth device. The
pairing procedure is controlled by your phone.
Different phones have different menu structures.
You should, therefore, refer to your phone’s user
guide or dealer support if you cannot complete
the pairing procedure with the generic steps
described here.
To Next Page
Loading...
Need help?
General
