3130
Using uDirect 2 with FM
uDirect 2 can be used together with FM
equipment.
1. Place the FM transmitter near the
sound source and turn it ON.
2. Turn the FM receiver ON if
required.
3. uDirect 2 must be switched ON
and worn correctly.
4. Attach your FM receiver to the
uDirect 2 via the FM input as
shown in the picture.
When FM is detected, you will hear the FM
notification tone for streaming through your
hearing aids. The FM notification tone is similar
to a phone ringtone.
The power indicator is lit as long as you press
a uDirect 2 button. Green confirms a good
uDirect 2 battery state, red indicates that you
need to charge the uDirect 2 battery.
2 minutes after unplugging the neckloop both
indicator lights will switch off and the uDirect 2
disconnects Bluetooth to save power.
Operating distance
If uDirect 2 is used as a handheld remote control
(without neckloop):
Maximum distance 80 cm/32’’
Hold uDirect 2 as shown
To Next Page
Loading...
Need help?
General
