2322
the previously-active program or audio source
(such as the audio jack input).
You can also end a call by operating your phone
instead of your uDirect 2.
Advanced phone options
Rejecting a call
If you prefer not to answer an incoming call,
press and hold the access (
) button on your
uDirect 2 for two seconds until the ringtone
stops. Using your phone to reject the call will
have the same effect.
Pressing the home (
) button will reject the call
and the hearing aids will switch to the startup
program.
Using cordless phones (DECT) or older phones
with headset profile only
If your phone only supports the headset
profile (HSP), the connection must be initiated
manually for outgoing calls. This often applies to
cordless home phones (DECT standard).
For these phones, the audio indicator might not
blink blue even if the phone is paired.
1. Dial the number you want to dial on your
phone, or select it from the phone book.
2. Briefly press the connect (
) button, then
wait 5 seconds.
3. The dialing process will automatically start
and the audio indicator will turn solid blue.
You may hear a confirmation beep through
your hearing aids.
Ending a call
To end a phone call via your uDirect 2, briefly
press the access (
) button. The call will
terminate and your hearing aids will return to
To Next Page
Loading...
Need help?
General
