48
LUBRICATION CHART
PART TO BE LUBRICATED LUBRICANT
Engine crankcase 20W/50 Detergent Oil
Transmission 20W/50 Detergent Oil
Air cleaner JR Filter Oil
Telescopic forks 5wt-10wt Fork Oil
Final Drive 80/90 Gear oil
Brake pedal shaft Grease
Drive shaft universal joint Grease
Lever pins & end pieces of clutch & hand brake cables Grease
Wheel bearing Grease
Front forks Spindle oil & WD-40
Carburetor throttle control twist grip Grease
Speedometer flexible drive cable & speedometer axle Spindle oil
Steering column bearings Grease
REQUIRED LUBRICATION
The Ural has been certified for EPA with SAE 20W/50 petroleum based detergent oil. This oil is
used in both the engine and transmission.
CARE OF MOTORCYCLE PAINT
When washing the motorcycle, use a weak stream of cold or slightly heated water. Never use a
pressure washer! Do not remove dust and mud by rubbing the surface with a dry cloth as sand
particles will degrade the surface and the paint will rapidly lose its brilliance. While washing, do not
use soda solution, kerosene, citric acids or mineral oils. If the surface is stained with mineral oil,
degrease by wiping with a rag. If after removal of mud and dust with a jet of water, some dirt is left
on the surface, remove it with the help of a sponge, a soft hair brush or a flannel and water, but not
allowing separate water drops to dry out on the surface. Finally, polish the painted surfaces with a
dry soft flannel.
To repair painted areas, each motorcycle is furnished with a bottle of matching touch up paint.
For patching proceed as follows:
· clean the surface with turpentine
· rub the damaged spot with a waterproof abrasive cloth and water rub thoroughly
· paint using a soft brush or a spray gun.
To Next Page
Loading...
Need help?
General
